Both the screen and the keys are backlit. The 6160 keypad has a 32 character display screen which features English status messages. The Honeywell 6160 is an alphanumeric keypad and provides full functionality for programming and controlling a Honeywell Vista series hard-wired security system. Refer to the control panel's programming guide for the complete list of programming commands and explanations. Set keypad-related data fields: *21 Quick Arm Enable, *23 Forced Bypass, and *84 Auto Stay Arm. Use fields *197, *198, and *199 to turn on a partition number display, exit time interval display, and select fail display mode. Use data fields *190-*196 to enable keypad addresses, assign a partition, and enable sound options. Function keys must be held down for 2 seconds to activate an alarm. These keys may be programmed for panic alarms, stay, away and other special functions. Use data field *57 to program the 4 function keys on the right hand side known as A, B, C and D. Or power up the keypad and within 50 seconds of powering up, press the star (*) key and the pound (#) key at the same time, this method needs to be used if ✱98 was used to exit program mode. To enter programming, enter the installer code (Honeywell's factory default installer code is 4112) followed by the numbers 800. Keypads programmed with the same address will provide unpredictable results. Each keypad must be assigned a unique address. The main keypad address should be addressed to 16. Once installed, to enable the 6160 keypad, start by setting the address at the keypad. Install a Honeywell 6160 keypad to the control panel's keypad terminals as shown in the installation manual.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |